Frequently Asked Question
To perform a bandwidth on your Frame Grabber, please follow the steps listed below using Vision Point application.
1. Open Vision Point application and detect
2. Select a Frame Grabber device
3. Open Frame Grabber tab
4. Expand "Device Control" category
5. Expand "Bandwidth test" category
6. Set "Payload buffer size (MB)" to the desired one
7. Execute "Perform bandwidth test" command
8. Wait a few seconds
9. "Bandwidth test status" will change to "Running"
10. Check succession "Finished" status in "Bandwidth test status"
11. The result can be seen as the "Average transfer speed" value
Note: You can find all status enumeration parameters in "KAYA Frame Grabber Programming Guide" document, located in the "Vision Point Documentation" folder (after the application is installed).
A visual example of the process can be seen in the image below: